Добро пожаловать, Гость. Пожалуйста, войдите или зарегистрируйтесь.
Не получили письмо с кодом активации?


Do you need a laser cutting machine?

0 (0%)
0 (0%)

Проголосовало пользователей: 0


Автор Тема: How to properly maintain a laser cutting machine?  (Прочитано 362 раз)

0 Пользователей и 1 Гость просматривают эту тему.

Оффлайн Baiweilaser

  • Новичок
  • *
  • Пол: Мужской
  • Город: China
  • Карма: +0/-0
  • Развернуть
How to properly maintain a laser cutting machine?
« : 04 Ноябрь 2022, 10:59:03 »
Laser cutting machine maintenance and maintenance are as follows.
1. cooling system to ground, the water tank and water circuit to be cleaned regularly, cooling temperature control tank temperature control point to be appropriate, otherwise it will cause damage to the laser tube dew, power down. Cooling water head off, the service life is greatly shortened, and sometimes can not work, resulting in constant replacement of the tube.
2. laser cutting machine laser tube installation pivot point to be reasonable, the pivot point should be at 1/4 of the full length of the laser tube, otherwise the laser tube spot pattern will become bad, sometimes the spot will become several points over a period of time. As a result, the laser power drop can not meet the requirements.
3. The waterproof protection device should be checked and cleaned frequently. Cooling water often can not flush the protection float switch or water protection float switch is not reset, can not use short circuit method to solve the problem.
4. The suction device should be checked and cleaned regularly and the fan air duct should be cleaned. Otherwise a large amount of soot cannot be discharged and will quickly contaminate the lens and laser tube and cause the mechanical and electronic components to oxidise easily, resulting in poor contact.


How to properly maintain a laser cutting machine?
« : 04 Ноябрь 2022, 10:59:03 »

Тэги: fiber laser cutter 

Rambler's Top100